どのようにHP HP0-Y50認定試験の準備をしているか

pass4test

2015年06月17日 17:26

NO.1 Which exhibit shows the better Open Shortest Path First (OSPF) area scheme and for which reason?
A. Exhibit 1 because it allows the application of access control lists (ACLs) between users and the data
center
B. Exhibit 1 because the campus and data are separate areas
C. Exhibit 2 because every area has similar numbers of routers
D. Exhibit 1 because every area has fewer than 50 routers
E. Exhibit 2 because every area has fewer than 35 routers
Answer: B

HP問題   HP0-Y50日本語   HP0-Y50教育資料   HP0-Y50日本語講座   HP0-Y50試験解答

NO.2 A company has several branch offers, each of which has four VLANs: one for employees, one for
guests, one for network infrastructure local services. At each office, a VLAN has a maximum of 200
endpoints. Each branch office represents one Open Shortest path First (OSP) architect has created
the plan shown in the exhibit for IP addressing.
What is a potential disadvantage of this design?
A. The subnets are large enough to accommodate fewer endpoints. But not large enough to
accommodate 200 end points
B. It makes it more complicated for the company to add subnets to branches in the future.
C. The scheme uses private network addressing space, which is not permitted for use with OSPF.
D. The address blocks do not provide enough IP addresses for the devices currently at each branch.
Answer: B

HPソフト版   HP0-Y50教材   HP0-Y50   HP0-Y50解答例   HP0-Y50口コミ   HP0-Y50フリーク

NO.3 Refer to the exhibits. Exhibit 1
Exhibit 2 A customer has a existing solution, which is shown in Exhibit 1. (The solution actually
includes more access layer switches than shown) in the existing solution, each access layer switch
routes traffic.
A network architect is proposing the HP FlexCampus solution shown in exhibit 2 in this proposed
solution, the core intelligent Resilient Framework (IRF) virtual switch routes traffic, but the access
layer switches do not.
The customer likes that in the existing solution STP does not block either access layer uplink. The
customer also likes that the existing solution does not require Virtual Router Redundancy Protocol
(VRRP).
What should the architect tell the customer about the benefits of the proposed solution?
A. Although the IRF core must implement VRRP, STP does not block either access layer uplink, letting
failover occur more quickly
B. STP does not block either access layer uplink, and routing redundancy is provided without VRRP
C. Although the IRF core must implement VRRP, VRRP is easier to set up than a dynamic routing
protocol on all the switches
D. STP will block one uplink on each access layer switch, but IRF enables failover to occur much more
quickly
Answer: D

HP割引   HP0-Y50学習教材   HP0-Y50リンクグローバル   HP0-Y50クエリ

NO.4 The exhibit shows the topology for a network with 30 access layer switches (only two are
shown).
Every switch-to-switch link is a Gigabit link. Every area network (VLAN) interface runs. Open Shortest
Path First (OSPF) and has the IP address shown in the exhibit. The other interface settings are
defaults.
The access layer switches support several more VLANs not shown in the exhibit and also run Multiple
Spanning Tree protocol (MSTP) loops.
What is one recommendation for enhancing convergence time and resiliency for this solution?
A. Place all of the switch-to-switch links in the same VLAN.
B. Lower the cost of the VLAN interfaces to reflect the high speed of the links.
C. Add a BPDU filter to the VLAN interfaces shown in the exhibit.
D. Raise the OSPF times on the VLAN interfaces.
Answer: C

HPクエリ   HP0-Y50スキル   HP0-Y50   HP0-Y50ワークスペース   HP0-Y50

NO.5 A customer has Voice IP (VoIP) phones that support Link Layer Discovery Protocol Media
Endpoint Discovery (LLDP-MED).
The phase need to receive their VLAN ID using this protocol.
The network architect is proposing HP 5500-48G-PoE+EI switches.
Each user computer connects to the phone, which then connects to the Ethernet jack.
LLDP is enabled on the switch. Each Edge port is trunk port that permits VLAN 10 (the user VLAN) and
VLAN 20 (the voice VLAN).
Which other setting recommended on the edge port?
A. The voice VLAN is enabled
B. The PVID is set to VLAN 20
C. LLDP Cisco Discovery Protocol (CDP) compliance enabled
D. The LLDP voice VLAN ID is set to 20
Answer: C

HP一発合格   HP0-Y50対象者   HP0-Y50成果物

NO.6 A network architect is choosing fabric module for an HP 10500 Series Switch. Which factors
affect the choice?
A. The environment in which the switch will be installed and the direction of the airflow
B. The number of IPv4 and IPv6 routes that the switch must support in its routing table
C. The type of I/O modules and whether full bandwidth must be supported on all ports at the same
time
D. The type of management modules and whether these modules operate in hot-standby mode
Answer: C

HP受験期   HP0-Y50練習   HP0-Y50開発入門   HP0-Y50試験スクール

NO.7 Refer to the exhibit.
A network architect has planned redundant links as shown in the exhibit. What should the network
architect do to ensure that the redundant link design is truly resilient?
A. Implement the features such as link aggregation, backplane stacking, and intelligent Resilient
Framework (IRF)
B. Add another link between the Layer 2 switches and the core so that up to the two links can fail
C. Implement a feature such as bidirectional forwarding detection (BFO) on each redundant link
D. Make sure that each HP 10508 switch is configured as a root in one Multiple Spanning Tree
Protocol (MSTP) instance
Answer: C

HP試合   HP0-Y50   HP0-Y50   HP0-Y50受験期

NO.8 A network architect is planning the top of the Rack (ToR) switches for a data center solution.
The customer has a hot aisle/cool aisle configuration.
Which characteristic of the switch relates to this plan?
A. The great dissipation (as measured in Watts)
B. The voltage as related to maximum power consumption
C. The number of power supplies by the switch, including redundant ones
D. The location of the air intake and output and whether the airflow is reversible
Answer: D

HP試験過去問   HP0-Y50教育資料   HP0-Y50認定試験   HP0-Y50


HPのHP0-Y50試験はIT領域で人気がある重要な試験です。我々はIT領域の人々にショートカットを提供するために、最高のスタディガイドと最高のオンラインサービスを用意して差し上げます。Pass4Testの HPのHP0-Y50試験問題集は全ての試験の内容と答案に含まれています。Pass4Testの模擬テストを利用したら、これはあなたがずっと全力を尽くてもらいたいもののことが分かって、しかもそれは正に試験の準備をすることを意識します。


Pass4TestはIT認定試験のHP0-Y50問題集を提供して皆さんを助けるウエブサイトです。Pass4Testは先輩の経験を生かして暦年の試験の材料を編集することを通して、最高のHP0-Y50問題集を作成しました。問題集に含まれているものは実際試験の問題を全部カバーすることができますから、あなたが一回で成功することを保証できます。


試験番号:HP0-Y50
試験科目:「Architecting HP FlexNetwork Solutions」
一年間無料で問題集をアップデートするサービスを提供いたします
最近更新時間:2015-06-16
問題と解答:全133問 HP0-Y50 トレーニング費用

>>詳しい紹介はこちら


 

目の前の本当の困難に挑戦するために、君のもっと質の良いHPのHP0-Y50問題集を提供するために、私たちはPass4TestのITエリートチームの変動からHPのHP0-Y50問題集の更新まで、完璧になるまでにずっと頑張ります。私たちはあなたが簡単にHPのHP0-Y50認定試験に合格するができるという目標のために努力しています。あなたはうちのHPのHP0-Y50問題集を購入する前に、一部分のフリーな試験問題と解答をダンロードして、試用してみることができます。


ショートカットを選択し、テクニックを使用するのはより良く成功できるからです。HP0-Y50認定試験に一発合格できる保障を得たいなら、Pass4Test のHP0-Y50問題集はあなたにとってユニークな、しかも最良の選択です。これは賞賛の声を禁じえない参考書です。この問題集より優秀な試験参考書を見つけることができません。このHP0-Y50問題集では、あなたが試験の出題範囲をより正確に理解することができ、よりよく試験に関連する知識を習得することができます。そして、もし試験の準備をするが足りないとしたら、HP0-Y50問題集に出る問題と回答を全部覚えたらいいです。この問題集には実際のHP0-Y50試験問題のすべてが含まれていますから、それだけでも試験に受かることができます。


今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。Pass4Testが提供したのオンライン商品がIT業界では品質の高い学習資料、受験生の必要が満足できるサイトでございます。


今この競争社会では、専門の技術があったら大きく優位を占めることができます。IT業界では関連の認証を持っているのは知識や経験の一つ証明でございます。Pass4Testが提供した問題集を使用してIT業界の頂点の第一歩としてとても重要な地位になります。君の夢は1歩更に近くなります。資料を提供するだけでなく、HPのHP0-Y50試験も一年の無料アップデートになっています。


Pass4Testは最新のC2010-511試験問題集と高品質のDC0-260認定試験の問題と回答を提供します。Pass4TestのC2070-588 VCEテストエンジンとP2090-046試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のC2040-415トレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。試験に合格して認証資格を取るのはそのような簡単なことです。


記事のリンク:http://www.pass4test.jp/HP0-Y50.html


関連記事